This is the process of how to paint and make angel eyes for your front lights.
Before
Step 1
-Remove Screws and the plugs
Step II
-This is the complex part. You have to remove the 2 metal clips from the lights, and all removable parts (caps, bulbs, plastic rings etc.)
-Put the lights in conventional oven at 250 degree for 15 min, in a oven plate no directly over the grill. (make one at a time)
-Use a thin solid plastic stick to separate the plastic cover. Do not use a metal stick (like a screw driver), or you can break them.
The car w/o the lights
Step III - Paint
If you dont want to paint this area (blue in the pic) use tape, don't use a strong tape or you will remove the chrome area
Step IV - The angel eyes
I use a strap for the lower area (make a little hole), and super glue for the upper area
Step V
put back the lighrs and conect the angel eyes to the connect the angel eyes to the parking lights. The plugs contain 3 terminals. center is ground. for check who is the terminal of the parking lights. you turn on the parking lights with a tester you check this
Step VI
Repeat the step II to close them back. (mocpac_ser)- I recomend to use pluming clear silicon to renforce plastic cover so no umidity enter to the lights.
You are DONE.
Author: mopac
